The wire rope clamp should be noticed when using:
(1) The method of steel wire clamp is to fasten the clamping seat on the working section of the Wire rope, the U-shaped bolt is fastened at the end of the wire rope, and the wire rope clamp shall not be arranged alternately on the wire rope. (2) The minimum number of wire rope clips needed for each connection. Wire rope clip When the wire rope is properly disposed, the strength of the fixed place is at least 80% of the wire rope's own strength, and the clamp is tightened further after 1 and 2 times in actual use. (3) The rope clip closest to the sleeve ring should be as close to the sleeve ring as possible, and when fastening the clamp, Wire rope clip the reasonable force of each clamp should be considered, and the rope clip farthest from the ring should not be fastened first alone. (4) In order to facilitate the inspection of joints, can be at the end of the clip head about 500mm after a chuck, and the line release a "Safe Bend." When the wire rope of the joint is sliding, the "safety bend" is straightened and the relevant safety precautions should be taken immediately.
The main function of the wire rope clamp is to fasten the wire rope temporarily or to the corresponding hand rope when it is worn around the emu. In addition, Wire rope clip this part can also be used as cable wind rope line fixed, can be said to be a very wide range of applications. At present, especially hoisting and hoisting operation, the wire rope clamp is widely used. So what do we need to pay attention to in the design of wire rope chuck?
Notes for design of wire rope clamp general in the design of steel wire rope chuck, we need to pay attention to some key points of design. Let us give a few examples to illustrate: The card head size must be with the wire rope thickness, in addition to the U-Ring inside the net distance also need to pay attention to the diameter of the wire rope 1~3mm, once the net distance is too large, Wire rope clip then it will cause the rope can not be tightened. In the design of wire rope card head, also need to pay attention to its material. The general card head is the use of carbon steel material, the casting steel wire rope head is generally used in the static tie knot, as well as the rope line fastening, such as the direction, for example, for example, power communication lines, as well as bundling fastening and other projects have applications.
For the corresponding arrangement between the rope card spacing, the general case is the size of the wire rope diameter $number times, the corresponding rope card must be a smooth arrangement. First of all, the corresponding part of the U-ring should be stuck on the line side, while the other side of the main rope should be placed on the platen, which is also needed attention in the design. In addition, depending on the direction of use, Wire rope clip for the design of the Chuck will also take a flexible approach, such as material or structure and so on.
Steel Wire Clamp Features: For the wire rope card head, it must pay attention to its strength. Often the strength of the wire rope chuck is the most critical part, it can guarantee the security we use, and the corresponding appearance of the transition is relatively smooth. Due to the lifting operation of the corresponding safety load is relatively large, can be very good against the impact load, so its service life will be very long.
For the Chuck design, we will first introduce here. Everyone for the card head design related knowledge is not in the mind have a certain understanding? Simply speaking, Wire rope clip the steel wire clamp design can be very well applied in various industries. Because of its unique shape, so that the entire part in the physical stress can do very good results.